From wired to wireless we have the sensor for your Dataterm.
The Dataterm Wireless Upgrade Kit is for those people who already have a backlit Dataterm IHC with a Green, Amber or Blue / White Display. Simply swap the existing programmer for the wireless enabled programmer and place the wireless sensor where required. Buying this wireless upgrade kit will enable you to easily position the wireless sensor anywhere around your home to give you better control where you need it. You get, 1 x Wireless Enabled Dataterm Programmer 1 x Wireless Remote Sensor 2 x Duracell AA Batteries or equivalent! If you have not already got a Dataterm but want the wireless option simply order the required Dataterm and select the wireless version. More Details
The remote sensor can be used on all Dataterm and iTC products where the programmer needs to be kept concealed to avoid tampering, being easy to fit, stylish and unobtrusive it will compliment any Warmworld system whatever its age. Use 1 per heating zone, SCREENED CABLE MUST BE USED to connect this accessory. Remote sensors come as standard with all Multizones but are optional on Standard and Combi versions of Dataterm. Screened Cable More Details
Used as an optional extra on all Dataterm and iTC programmers where you want to conceal the programmer and monitor the temperature over a wider area to achieve an average temperature reading i.e. large room or church hall etc. Remember to order the correct amount of SCREENED CABLE to run from the programmer through to each sensor. Screened Cable Sold in pairs, 1 pair = 1 zone.Our averaging sensors are NOT the same as our Standard Single Remote Sensors, hence the difference in cost. Use in domestic or commercial situations alike. Wireless Version available for Wireless Dataterm Variants - Please contact us with you Site Code and Site Ref No. listed on your Wireless Dataterm Programmer! NOT FOR iTC PRODUCTS. More Details
This wireless remote sensor is designed to work with Dataterm Wireless Products. If you need a replacement for any reason we can match a wireless sensor to work with your particular Dataterm programmer, all you have to do is advise us of your unique site code. This can be found on the rear of your Dataterm programmer, not all programmers have wireless capabiliy. Only MK4 Dataterm programmers are suitable, if there is no site code then it is probably not equipped with our wireless receiver. If this is the case please see our Wireless Upgrade Kit. More Details
- Showing 1 - 5 of 5 results